Revolectrix GT500 Operation & User’s Manual

14, Revolectrix GT500 Example 1: Configuring Smart Power Management 1. This example will show you how to configure a 12V DC power supply and a 12V Lead Acid battery for GT500 for the first time. Although we use a 12V DC power supply in this example, any input source may also be used. 2. Connect GT500…

18, with the time status information. 15. To change the current setting, press ENTER. The current setting you have previously set in the CHARGE AMPS option will be highlighted and you can adjust the setting if desired. Press ENTER again to set a new charging current or press BACK to discard…

24, Advanced Settings – Cycle Settings Cycles – sets the number of charge and discharge cycles. Cool Down – sets the amount of time for the pack to cool down between charges and discharges. End Cycle – end cycling with a charge or discharge. Advanced Setti…

8, Regenerative Discharge Regenerative discharge routes most of the energy from the pack being discharged back into the Lead Acid battery powering the GT500. This feature is only available when the GT500 is powered from a Lead Acid battery. Regenerative discharge supports up to 20A, 5…

17, a. The Cell Type option allows you to switch between LiPo and LiFePO4 (or A123). b. The Charge Amps option allows you to adjust the current for charging the LiPo pack. The allowable range is 25mA to 20A. c. The Chg V/cell option sets the cell end voltage of the LiPo pack. d. Sel…