Myron L Ultrameter 6P Operation Manual

24, Cell Check For Instruments with Software Version 2.10 & Later. In these versions, a Cell Check feature has been added to further increase the performance of your instrument. This is especially important when in RES mode reading High Resistivity or Ultrapure waters. This fea…

25, II. USER MODE CALIBRATION LINK A new function has been added to the Ultrameter that makes calibration of the unit while in "User" mode easier, and more repeatable and accurate than other calibration methods. It is recommended that this calibration method be used to provide the hi…

2, 7-11-00 Reference Junction under Glass pH Bulb MS MR pH 6P ORP COND RES TDS These 5 Measurement keys will: • Turn instrument on. • Measure parameter. • Exit any function. (Built-in Electrodes) Preprogrammed variable conductivity/ TDS ratios Parameters (5) Wrist/neck strap slot …

19, Myron L Ultrameter 6P to indicate a certain setpoint or minimum concentration or trend. The Ultrameter gives the user the capability to take data in “KCl conductivity units” to compare to older published data, in terms of NaCl or 442, or as may be appropriate. The Ultrameter can be used to re…

17, XIII. ACCESSORIES A. Conductivity/TDS Standard Solutions Your Ultrameter has been factory calibrated with the appropriate Myron L Company NIST traceable KCl, NaCl, and our own 442 standard solutions. Most Myron L conductivity standard solution bottles show three values referenced …