VisionNet 63303 Installation & Operating Manual

5, Vision.net Control Station Installation & Operation Guide 3 PREFACE About this Guide The document provides installation instructions for the following Vision.net products: • Slider Stations: 63303, 63306, 63309, 63312 and 63315 • Button Stations: 63321, 63322, 63324 and 63328 • Po…

3, Vision.net Control Station Installation & Operation Guide 1 Important Safeguards When using electrical equipment, basic safety precautions should always be followed including the following: a. READ AND FOLLOW ALL SAFETY INSTRUCTIONS. b. Do not use outdoors. c. Do not mount near…

6, VisionNet 63303 Installation & Operation Guide Vision.net Control Station 4 QUICK START This section is designed for experienced technicians in order to get a standard Vision.net Station up and running quickly. Use the following checklist: Step 1. Install unit (refer to "Installation" on page 5). …

8, Installation & Operation Guide Vision.net Control Station 6 Installation Steps To install slider/button stations: Step 1. Unpack unit and inspect for any signs of shipping damage. Step 2. If this is a slider station, remove slider knobs by pulling off (Figure 3). Step 3. Remove facep…

10, Installation & Operation Guide Vision.net Control Station 8 VISION.NET STATION OPERATION MODES Overview Vision.net stations can be set in either Standard Mode or Configurable Mode. The default setting for the unit is Station ID 1. A station, configured in either Standard or Configurable Mode, …

11, Vision.net Control Station Installation & Operation Guide 9 Operation Selecting a Scene: Typically, a 7-button station provides access to seven Presets (1-7). To select a Preset, press and release the appropriate button on the keypad. The LED will change to its active state. Programm…