Alinco DX-SR8 Instruction Manual

95, 93 Appendix Specifi cations General DX-SR8 ALL MODELS Operating mode J3E (USB, LSB), A3E (AM), A1A (CW), F3E (FM) Number of memory channels 600 channels simplex Antenna impedance 50 ȍ unbalanced Frequency stability ± 1ppm Power requirement 13.8 V DC ±15 % (11.7 to 15.8 V) Ground method Negati…

3, 1 Contents Contents ...........................................................................................1 WARNING .........................................................................................5 ALERT .................................................................................…

8, Alinco DX-SR8 6 WARNING Risk of explosion if battery is replaced with an incorrect type. Dispose of, or recycle used batteries according to your local regulations. The manufacturer declines any responsibilities against loss of life and property due to a failure of this product when used with or as a p…

49, 47 Chapter 3 Memory Features 3.1 Basics This transceiver has three memory banks. 200 memory channels are available in each bank, for a total of 600 channels. Each can retain different operating data such as receive and transmit frequencies mode, tone etc. It is useful to store regular…

76, 74 Chapter 6 Parameter Setting Mode (Set mode) (B) B10S: The scan stops regardless of a signal by all means, and will resume scanning after 10 seconds. B20S: The scan stops regardless of a signal by all means, and will resume scanning after 20 seconds. B30S: The scan stops regar…

2, HF Transceiver DX-SR8T The FCC Part 15 approval is not required for amateur-radio use of this device in USA/Canada. Copyright © All rights reserved. No part of this document may be reproduced, translated or transcribed in any form or by any means without the prior permission of Alinc…