Roberts R100 Instruction Manual

117, Specifi cations Power Requirements Mains 100 - 240 volts AC, 50 - 60Hz only (use only the supplied adaptor) Connectivity Wired Ethernet 10/100M bits/sec via RJ-45 connector WiFi 802.11 b, g, n or a supported with WEP and WPA / WPA2 encryption Compatible…

22, 19 Internet Radio Internet Radio - the basics Before you can use your radio to listen to broadcasts via the Internet, it is necessary to have connected it to your computer network using either the wireless (WiFi) connection or the wired Ethernet connection (RJ-45 socket) locate…

52, 49 Stereo / Mono switching If the FM radio station being listened to has a weak signal, some hiss may be audible. It is possible to reduce this hiss by forcing the radio to play the station in mono rather than stereo. 1. Select the FM radio mode (see page 6) and tune to the required FM sta…

17, 14 Confi guration Connecting to your computer network - cont. If you have followed the steps on the preceding pages successfully, your radio will have connected to your router, and then made a connection to the Internet and set its clock. If this is the case, then y…

81, 78 Setting the clock format The clock display used in Standby mode and on the playing mode screens can be set to 12 or 24 hour format. The selected format is then also used when setting the alarms. 1. With your radio switched on, press the Menu button to access the menu for the current…

40, Roberts R100 37 Selecting a DAB radio station 1. When playing a DAB radio station, the display normally shows the name of the current station with other related information. 2. Press the Tuning Up or Down buttons to access the radio station list and to scroll through the available stations. 3. Press the Sele…