Taymor Concierge 300 Operation & User’s Manual

35, PROGRAMMING RESTORE FACTORY SETTING IMPORTANT: 1. All existing user entry codes and the current programming code will be deleted. 2. The lock will be restored to preset programming with the programming code of 1-2-3-4-5-6. 3. Please change the programming code and add a ne…

1, CONCIERGE 300 PROFESSIONAL SERIES ELECTRONIC DEADBOLT USER GUIDE REV. 07/15 IMPORTANT: Before first use, please read page 20 in the User Guide for important instructions. Concierge 300 install booklet ENGLISHnew.indd 1 7/15/15 9:12 AM …

22, Taymor Concierge 300 PLACE INTERIOR COVER OVER INTERIOR ASSEMBLY COMPLETE INSTALLATION 10 19 ® REGISTERED TRADEMARK OF TAYMOR INDUSTRIES LTD. Concierge 300 install booklet ENGLISHnew.indd 22 7/15/15 9:12 AM …

30, PROGRAMMING DELETE ALL EXISTING USER ENTRY CODES AT ONCE Follow these steps: 1. Press [SET] button for 2 seconds. The Red LED will light up and a “beep” will sound twice. You are now in programming mode. 2. Enter 1-2-3-4-5-6 (or current Programming Code) and press the b…

21, ® REGISTERED TRADEMARK OF TAYMOR INDUSTRIES LTD. 18 INSTALLATION 9 INSERT 5/16” (8 mm) SCREW (2) AND TIGHTEN INSERT 13/16” (20 mm) SCREW (1) AND TIGHTEN Concierge 300 install booklet ENGLISHnew.indd 21 7/15/15 9:12 AM …

10, 7 ® REGISTERED TRADEMARK OF TAYMOR INDUSTRIES LTD. DOOR PREPARATION 3.2 DRILL HOLES c. Drill a 1” (25 mm) hole in the door edge for the latch. d. Use faceplate as a pattern for mortise and pilot holes. Chisel 5/32” (4 mm) deep. Faceplate should fit flush. Note: For d…