TE 68026 Manual, Original Instructions

1, 1 of 5 © 2014 TE Connectivity family of companies All Rights Reserved *Trademark TE Connectivity, TE connectivity (logo), and TE (logo) are trademarks. Other logos, product, and/or company names may be trademarks of their respective owners. TOOLING ASSISTANCE CENTER 1-800-72…

2, TE 68026 408-2363 Rev K 2 of 5 3.1. Double-Face Terminal or Splice 1. Open tool handles FULLY. 2. Place the foil between faces of the tab end of terminal or splice, and squeeze the faces together manually. See Figure 3, Detail A. 3. Place the tab end and foil between the crimping dies as …

3, 408-2363 Rev K 3 of 5 6. For long-tongued terminals, several crimps will be necessary. These crimps should overlap to ensure that the entire tab end is crimped. 7. Crimp the wire barrel using the appropriate tooling (refer to Figure 2) according to the instructions packaged with th…

4, 408-2363 Rev K 4 of 5 4. Inspect the head assembly, with special emphasis on checking for worn, cracked, or broken jaws. If damage to any part of the head assembly is evident, the tool must be evaluated and repaired. See Section 5, REPLACEMENT AND REPAIR. Jaw Closure Inspection This …

5, 408-2363 Rev K 5 of 5 b. Jaws grasp the NO-GO element. If above conditions are met, the ratchet is performing satisfactorily. If not, see Section 5, REPLACEMENT AND REPAIR. 3. Re-install the dies, and secure them with the roll pins. 5. REPLACEMENT AND REPAIR Customer-replaceable pa…