Pentax K10D 76830 Service Manual

31, 30 ② A13 ③ Main body ④ TY-CNL-D1.7x4.0 x2 3. 0-A101 (Front housing block) ① Apply DC 2V to the mirror motor, and set mirror up position. (Red --- +) ② To prevent the damage of SI-LED, attach mount cover. Then put downward. ③ Put main body to the front h…

12, 11 5. 0-T100 (Main PC board) ① Peel off the BT (5x15)… (x6) ② Peel off T90 ③ Peel off U5 (76030- A35) ④ Unsolder 7 lead wires ⑤ Unsolder 2 lead wires ⑥ Unsolder 4 lead wires ⑦ Unsolder 6 lead wires ⑧ Unsolder 4 lead wires ⑨ Disconnect flex from connector (2 …

24, 23 7. [ADJUST] POSITIONING 1ST AND 2ND MIRROR [Required equipment] 1 st mirror angle (45°) adjusting jig, Mirror angle adjusting jig for 27830 (need modify),Mirror positioning scope. *Adjustment is performed by turning B58 (2 pcs). The Y-axis (the vertical direction) is adj…

68, 67 INFORMATION OF JIGS, TOOLS AND TESTERS FOR K10D Order No. * Exclusive use for K10D (76830) Program soft for 76830 (For SLR/digital/SR adjustment) No.95901-P410 Battery Adaptor for 76830 (BATT level adjustment/ battery consumption check) …

14, 13 9. O201 (LCD block) ① Unsolder 6 lead wires. ② Peel off [AE-L] SW from double stick tape. ③ Screw ④ TY screw (x2) ⑤ Lift up LCD block as shown figure below. ⑥ Disconnect O100 flex from connector. (Flip lock type) ⑦ Disconnect T700 flex …

10, Pentax K10D 76830 9 ⑦ Discharge the main capacitor Lift up the A301 then discharge the main capacitor by using 100Ω-1kΩ resistor. (Discharge between Blue and Brown (gray) soldering land on T750.) ⑧ Disconnect T51 flex board from connector. (Slide lock) ⑨ Unsolder lead 5 wires…