Allied Telesis AT-GS950/48 Operation & User’s Manual

48, Chapter 2: System Configuration 48 3. Use the pull-down menu to set the Clock Mode parameter to Local time. 4. In the Local Time Settings section, set the Date Setting (YYYY:MM:DD) to the current date in the YYYY:MM:DD format. 5. In the Local Time Settings section, set the Time…

160, Allied Telesis AT-GS950/48 Chapter 13: Virtual LANs 160 VLAN Index You must assign a unique number to each VLAN in a network. This number is called the Port-Based VLAN Index. This number uniquely identifies a VLAN in the AT-GS950/48 switch and across the network. Each port of a port-based VLAN can belong to …

392, Appendix B: AT-GS950/48 Default Parameters 392 Physical Interface Port All, 1 - 48 - Trunk -- Type 1000TX - Link Status Down Up/Down Admin Status Enabled Enabled/Disabled Mode Auto Auto/10Half/10Full/100Half/100Full/1000Full Jumbo Enabled Enabled/Disabled Flow Control Disabled Ena…

227, AT-GS950/48 Web Interface User Guide 227 5. Finally, the traps can be defined on the Trap Management page based on the Community or User Name. See Figure 84 for an illustration of how the user configuration tables are linked. Figure 84. SNMPv3 Table Relationships …

404, Appendix B: AT-GS950/48 Default Parameters 404 Binding Database Port port 1 All, 1 - 48 Binding Database Type Static Dynamic/Static Binding Database Lease Time none 10 - 4,294,967,295 seconds LLDP LLDP Disabled Enabled/Disabled Message TX Hold Multiplier 42 - 10 Message TX Inter…

217, AT-GS950/48 Web Interface User Guide 217 Note This name must match one of the User Names displayed on the SNMP User/Group page. See “Create User and Group Names” on page 213. If you enter a user name that has not been pre-defined on the SNMP User/Group page, the Community entry …