Allied Telesis AT-x900-12XT/S Configuration Manual

5, Page 5 | AlliedWare Plus™ OS How To Note: Switching Port speed, duplex mode, and polarity Port speed, duplex mode, and polarity In most networks, you will not need to change the port speed, duplex mode, or polarity, because the ports automatically negotiate suitable settings. This…

8, Page 8 | AlliedWare Plus™ OS How To Note: Switching Basic VLAN and IP configuration VLANs are configured as an attribute of switch ports. This means that you go into Interface Configuration mode to configure the switch ports, and specify the VLANs you want to associate with each s…

24, Page 24 | AlliedWare Plus™ OS How To Note: Switching Link Aggregation How to configure static aggregation This section describes how to use statically-aggregated ports instead of LACP. For the network diagram, see page 21. First create the VLANs and associate them with ports, by fol…

28, Page 28 | AlliedWare Plus™ OS How To Note: Switching Appendix: Complete configuration scripts Script for MSTP example ! service password-encryption ! log record-priority username manager privilege 15 password 8 $1$bJoVec4D$JwOJGPr7YqoExA0GVasdE0 ! platform jumboframe platform routingrati…

3, Page 3 | AlliedWare Plus™ OS How To Note: Switching Port Numbering Port Numbering Port numbers In the AlliedWare Plus OS, switch ports are named portx.y.z (e.g. port 1 .0. 1 ), where: z the first number (x) is the stack ID number z the second number (y) is the module number. For port…

22, Allied Telesis AT-x900-12XT/S Page 22 | AlliedWare Plus™ OS How To Note: Switching Link Aggregation Ports 1 .0.2- 1 .0.4 are in access mode. Enter the commands: awplus(config-vlan)#interface port1.0.2 awplus(config-if)#switchport access vlan 2 awplus(config-if)#interface port1.0.3 awplus(config-if)#switchport access vla…