SATO GT4e Manual 

9, Head close lever Label guide handle Head open lever Fanfold cover Label guide Maintenance screw Stopper screw Label guide handle Label damper Paper sensor Label damper stopper Memory cartridge Tilt the knob of the memory cartridge cover inside and remove the memory cartridge cover…

14, 6 7 8 Loosen the label guide knob, and adjust the slide guide so that it lightly touches the edge of the paper, and fasten the label guide knob tightly. Turn the head close lever (purple / CLOSE ) in the direction of the arrow, and close the printer head. Close the printer head tightly un…

13, 4 5 Loosen the label guide knob and set it forward. Pull up the label damper. Pass the paper under the label guide and paper sensor. When the knob of the label damper is pulled forward, the label damper will return to the original position. Label guide knob Label damper Label gui…

11, Feeding direction Feeding direction Feeding direction Feeding direction Front side Back side Front side Back side 3 mm 1.5 mm Front side Back side Folding perforation I-mark Folding perforation I-mark I-mark I-mark Front side Back side Setting the paper This printer can print on roll paper…

12, SATO GT4e Setting roll paper 1 2 3 Lift up the main cover. As you pull down the roll guide lever, move the roll guide to the edge, and tilt it. Set the paper to the roll paper feeder. Raise the roll guide and adjust it so that the roll will not move. Lower the head-open lever (purple)( ). The …

21, 7 8 Pass the paper under the label guide and paper sensor. Pull the label damper knob, and the label damper will return to its original position. Loosen the label guide knob, and adjust the slide guide so that it lightly touches the edge of the paper, and fasten the label guide knob tight…