SBIG STX Series Operating Manual

11, 1.5. Attaching the camera to a telescope. ue to the size of the largest CCD supported by the STX se N- in 1.6. Connecting the Relay Cable he camera contains opto-isolated relays to control a telescope during self-guiding or when auto diagram at right (Off-the-shelf cable 1.7. Attac…

16, SBIG STX Series you must carefully pry this connector loose and lift the digital board away from the camera. Care should be taken not to pull too strongly on the digital board far from the connector as this could bend the board and cause cracks in the delicate traces. Once the digital board i…

1, Operating Manual STX Advanced Series CCD Cameras SBIG Imaging Systems A Division of Diffraction Limited. 59 Grenfell Crescent, Unit B, Ottawa, ON Canada, k2G 0G3 Tel: 613.225.2732 | Fax: 225.225.9688| E-mail: [email protected] | www.sbig.com © 2016 Diffraction Limited. All rights reserv…

22, 2.2. Using the Camera This section gives you a quick introduction to using your Camera with CCDOps. Further information can be found in the CCDOps Manual on the CD ROM. Establishing a Link with CCDOps In order to control your Camera, CCDOps you must first establish a communications link…

7, Power Supply Extension Cable This 9 foot cable extends the distance the power supply may be placed away from the camera. It is also much more flexible than the short lead provided with the power supply. Finally, the extension cable adapts the four-pin output of the power supply to the six…

21, Linking the Drivers Once the Camera Drivers have been installed they need to be linked to the camera by Windows. Follow the instructions below to link your Drivers to the Camera. • First off, Windows can be finicky when it comes to linking the drivers. If you have any questions or…