Schenker XMG P504 Service Manual

23, Disassembly 2 - 14 Removing the Primary System Memory (RAM) 2.Disassembly Removing the Primary System Memory (RAM) The computer has four memory sockets for 204 pin Small Outline Dual In-line (SO-DIMM) DDR 3L type memory modules (see “Memory” on page 1 - 2). The total memory size is aut…

21, Schenker XMG P504 Disassembly 2 - 12 Removing the Hard Disk from the Secondary HDD Bay 2.Disassembly Removing the Hard Disk from the Secondary HDD Bay Note that the secondary hard disk (if installed) is located under the optical device bay (CD/DVD). 1. Turn off the computer, and turn it over, remove the battery ( …

18, Disassembly Removing the SSD 2 - 9 2.Disassembly Removing the SSD 1. Turn off the computer, and remove the battery ( page 2 - 5) and hard disk (page 2 - 9). 2. Remove the screws from the shielding plate ( Figure 5a ). 3. Remove the SSD shielding plate and remove the screw from the SSD ( Figur…

19, Disassembly 2 - 10 Removing the Optical (CD/DVD) Device 2.Disassembly Removing the Optical (CD/DVD) Device 1. Turn off the computer, and remove the battery ( page 2 - 5). 2. Locate the secondary hard disk bay cover and remove screws & ( Figure 6a ). 3. Remove the hard disk b…

17, Disassembly 2 - 8 Removing the Hard Disk Drive 2.Disassembly Hard Disk Size Note (Foam Rubber Insert) Note that the hard disks pictured on the following pages are all 9.5mm(H) hard disk drives. In some cases 7mm(H) hard disk drives will be installed. Figure 4 Foam Rubber Insert for …