Allstar AUD-S Installation And Owner's Manual

12, 12 NOTE: It is now necessary to turn on the power in order to change the Operating Mode (if applicable), program any changes desired to the operator’s other settings, check for proper performance of all the operator’s features to include the brake (if applicable) and clutch (adjust…

6, Allstar AUD-S 2) After the track is assembled, position track assembly onto the operator power head and attach with four 3/8”-16 x 1” bolts, lock washers and nuts (supplied in a separate hardware package #100470). NOTE: To keep #41 chain (used on 1/2 and 3/4 H.P. operators) centere…

8, 4) Mount the front mounting bracket (Item 9) to the mounting pad as shown in Figure 8. The location of the door’s torsion shaft may prevent you from placing the mounting pad in the location shown. Mount the pad as close as possible to three (3) inches above the door’s high ar…

16, The solenoid operated brake may require occasional adjustment. Adjustment is necessary if door tends to drift downward after reaching the open limit. Follow the instructions below and use Figure 21 as a guide. (1) Loosen shoe adjusting screw and bottom bracket arm of solenoid.…

11, Figure 15 OPEN TB1 STOPCLOSEOPEN COM CLOSE STOP NO REV NC REV PHOTO COM SINGLE ILOCK 24 VAC COM SAFE FINISH PHOTOBEAM 3-WIRE PHOTOBEAM MOTOR CONTROL BOARD Door Edge and Photoelectric Wiring See text on page 10 for operation when Safe-Finish™ or Access Alliance Safe-Finis…