SurfRAID LC16 Series Operation & User’s Manual

28, SurfRAID LC16 Series User’s Manual 28 3.3.2.5 NVRAM The NVRAM menu options control the configuration information. When using this menu option, the SurfRAID LC16 should be off-line. NOTE: Any changes made in this group will cause data on the drives to be permanently erased. Once a configu…

44, SurfRAID LC16 Series SurfRAID LC16 Series User’s Manual 44 APPENDIX D. GLOSSARY Array Management Software, Firmware The body of software that provides common control and management for a disk array. Array Management Software most often executes in a disk controller or intelligent host bus adapter, bu…

8, SurfRAID LC16 Series User’s Manual 8 1.1.1.2 Mirroring (RAID 1) Mirroring refers to the replication of data on two or more drives. Each drive contains a mirror image of the data on the primary drive. Virtual disk space equals to capacity of the smallest installed disk drive. Mirror…

40, SurfRAID LC16 Series User’s Manual 40 Error Message Explanation Number of disks found = y, needed = z The number of disks found (y) does not match the number of disks configured for. The number of disks needed (z) is required. Disk x not installed! A disk drive (x) is not i…

6, SurfRAID LC16 Series User’s Manual 6 About your User’s Guide Welcome to your SurfRAID LC16 Redundant Array of Independent Disks System User’s Guide. This manual covers everything you need to know in learning how to install or configure your RAID system. This manual also assumes that …

21, SurfRAID LC16 Series User’s Manual 21 3.2.3.4 Running Configuration Mode Configuration Mode through the monitor utility is similar to the LCD display. However, it has a graphical interface that allows for easier navigation through the menu system. Refer to section 3.3 THE SurfRA…