Sitecom WLM-2600 Operation & User’s Manual

26, WAN Settings This page allows you to manually configure the ADSL/WAN settings. The settings on this page require some knowledge concerning the WAN configuration. We advise less- experienced users to configure the WAN settings using the Wizard. VPI (Virtual Path Identifie…

25, You can configure your network and the router to use the Dynamic Host Configuration Protocol (DHCP). This page allows you to select the DHCP mode that this router will support. There are two different DHCP Modes: DHCP Server and DHCP Relay. When the router is acting as DHCP server…

3, Introduction Congratulations on your purchase of the WLM-2600 Wireless ADSL2+ Modem. This modem is fully compliant with 802.11b, 802.11g and 802.11n. This modem provides the best performance when used in combination with 802.11n client adapters. The WLM-2600 is not only a Modem or …

19, Sitecom WLM-2600 Status The pages in the status section provide you general information about the operational status of your device. Status The System status section allows you to monitor the current status of your modem/router: the UP time, hardware information, serial number as well as firmware …

35, You may need to define routes if your home setup includes two or more networks or subnets, if you connect to two or more ISP services, or if you connect to a remote corporate LAN. Click ‘Add route’ to add a self-defined route. Destination IP: The destination can be specified…