upcom UC-350E Operation & User’s Manual

35, UC-350E + ) Encod e r) User ’s ) M anu a l) 33 4.3.4 System Parameters In this field, users can set the corresponding channel parameters, such as the output IP address, output IP port number. This sub-menu will allow users to input additional channel PID information, IP output a…

7, upcom UC-350E UC-350E + ) Encod e r) User ’s ) M anu a l) 5  Connecting the Encoder’s signal cables.  Connecting the communication ports (if necessary). 2.2.1 Device’s Installation Flow Chart Illustrated as following： C onnecting) G rouding) Wire)and) P ower) C ord Acquis iti…

20, UC-350E + ) Encod e r) User ’s ) M anu a l) 18 !!1.1.3.2!!!A udio!!!PID !!!!!!!!!!!! !0x0301 !!1.1.3.3!!!A udio!1!!!PID !!!!!!!!!!!! !0x0302 !!1.1.3.4!!!A udio!2!!!PID !!!!!!!!!!!! !0x0303 !!1.1.3.5!!PMT !!PID !!!!!!!!!!!! !0x0300 !!1.1.3.6!!PC R !!PI D !!!!!!!!!!!! …

1, UC-350E+ Encoder User’s Manual Date : 2014-04-23 Version: 1.4 NMS Version: 5.0.20 SW: 0.07F HW: 1.0 …

45, UC-350E + ) Encod e r) User ’s ) M anu a l) 43 NIT: Network Information Table. 4.3.7.10.1 NIT Parameters User can set the network ID and network name in the field. Network ID: This describes the output TS Network ID. Network Name: This parameter describes the output TS’s network n…

27, UC-350E + ) Encod e r) User ’s ) M anu a l) 25 4.2.3 Adding Frequency Point To begin, add a Frequency Point. This can be done by clicking “Add Freq Point” within the ‘Edit’ drop down menu. Alternatively, users can right click on an empty section of the left hand side…