socomec DELPHYS MX Installation And Operating Manual

22, UPS/NTA GB/DMX-DMP JBUS.D Page 21 / 22 7. ENABLED CONTROLS TABLE: Address 0x15C0, 2 words CODE DESCRIPTION BIT ADDRESS REMARKS C00 0 C01 1 C02 2 C03 Eco-mode enabled 3 0x15C0 C04 Mode normal enabled 4 0x15C0 C05 5 C06 6 …

15, socomec DELPHYS MX UPS/NTA GB/DMX-DMP JBUS.D Page 14 / 22 JBUS/MODBUS TABLES IN PARALLEL SYSTEM CONFIGURATION Reminder In UPS parallel system configuration, there is only one J J B B U U S S / / M M O O D D B B U U S S interface. The addresses mapping gives the possibility to read data from each module a…

4, UPS/NTA GB/DMX-DMP JBUS.D Page 3 / 22 JBUS/MODBUS SERIAL INTERFACE INSTALLATION INSIDE DELPHYS MX / MP ‘Com-Slots’ localisation The « Com-Slots » integrates all communication interfaces, and it is located at the bottom of the UPS, on the right side. Slots 5 and …

3, UPS/NTA GB/DMX-DMP JBUS.D Page 2 / 22 INTRODUCTION General purpose This document provides required information of the J J B B U U S S / / M M O O D D B B U U S S protocol serial link. Before connecting a supervision equipment or BMS system (Building management sys…

23, UPS/NTA GB/DMX-DMP JBUS.D Page 22 / 22 ANNEX: SPECIFIC JBUS/MODBUS TABLES For specific needs To optimize the data traffic between the UPS and the remote equipment, DELPHYS MX / MP is able to sent in one frame all information, including states and alarms, and also mea…

21, UPS/NTA GB/DMX-DMP JBUS.D Page 20 / 22 6. MEASUREMENTS: Address 0x60, 48 words Code Measurements Units ADDRESS LSB byte REMARKS MO0 Load rate phase1 % 0x60 M01 Load rate phase 2 % 0x61 Set to 0xFFFF if one phase M02 Load rate phase 3 % 0x62 Set to 0xFFFF if one pha…