Solartron Metrology SI7500 Quick Start Manual

23, 5.0 Setting up the SI7500 (cont.) 502858 issue 1.1 5.0 Setting up the SI7500 (cont.) 21 5.8.1 Nominal With +/- Tolerances A nominal value is displayed between plus and minus tolerances. Press the +/-softkey to specify a nominal value with +/- tolerances, and then highlight the desired fie…

8, 3.0 Introduction to the SI7500 (cont.) 502858 issue 1.1 3.0 Introduction to the SI7500 (cont.) 6 Horizontal bar Vertical bar DialDigital readout (DRO) Graph of values Histogram of values Measurement data SPC data The SI7500's user interface screens include a digital readout of current va…

6, 2.0 Safety Information (cont.) 502858 issue 1.1 2.0 Safety Information (cont.) 4 WARNING Always disconnect the power cord from the source of AC power before unplugging it from the SI7500 power connector. The AC voltage available at electrical outlets is extremely dangerous and can cause…

19, Solartron Metrology SI7500 5.0 Setting up the SI7500 (cont.) 502858 issue 1.1 5.0 Setting up the SI7500 (cont.) 17 5.6 Creating A Part And Dimensions The SI7500's factory settings' default Part is 0. To add or change to a different Part, enter the Dimensions screen of the Setup menu and highlight Part. With the…

29, 5.0 Setting up the SI7500 (cont.) 502858 issue 1.1 5.0 Setting up the SI7500 (cont.) 27 5.9.1 UCL & LCL Or Xbar & r UCL & LCL The UCL and LCL fields are displayed when the subgroup size is 1 and the Xbar and r Ucl and Lcl fields are displayed when the subgroup size is gr…

3, Contents 502858 issue 1.1 Contents 1 Section Contents Page 5.8.2 Nominal With ++ Tolerances 22 5.8.3 Nominal With -- Tolerances 23 5.8.4 Nominal With Fixed Limits 24 5.9 SPC Configuration 25 5.9.1…