SOMMER twist AM Operating Manual

27, 27 46830V001-012016-Rev.A_EN 6.6 Installing operator CAUTION Risk of injury to feet! Falling parts could cause foot injuries. f Wear safety shoes. f Hold the operator  rmly until all 4 screws are tightly screwed in. Fig. 1 Fig. 2 1. Attach the operator on the post fitting or f…

46, 46 46830V001-012016-Rev.A_EN 1. Release the operator on the master door operator from the door arm. 2. Move the door leaf to the centre position. 3. Relock the operator with the emergency release lever. It might be necessary to move the door leaf a bit to lock it. 4. If present, brin…

60, SOMMER twist AM 60 46830V001-012016-Rev.A_EN 11. Operation Overview of door movements The sequence of movements of the door leaf is shown in the figures. The prerequisite for button assignment is that the door system is programmed, see Chapter "8.2. "Programming of end positions and operating forc…

25, 25 46830V001-012016-Rev.A_EN 6.3 Pre-assembly of operator arm Mechanical stops, so-called blocking elements, can be installed in the operating arm. These are additional safeguards for the door system. The blocking elements can be omitted if fixed stops are present. NOTE The operator switc…

36, 36 46830V001-012016-Rev.A_EN 7.6 Basic configuration DIP switches 7 and 8 are used to determine the positions for the master door operator, slave door operator and the closing sequences, see Chapter "3.8 Definitions". All DIP switches are set to “OFF” in the factory setti…