VTL TL2.5 Owner's Manual

16, CHAPTER 3 Operating the Preamplifier Connecting and Selecting Source Components The Input Selection for the preamplifier is marked for Video, Tuner, Tape, CD, Auxillary and Phono source components. The input connectors on the back panel of the preamplifier are correspondingly marked Video…

4, VTL TL2.5 Table of Contents CHAPTER 1 ...............................................................................................................................1 INTRODUCTION ......................................................................................................................…

27, both remotes may be interpreted as the same. If the functions with the same command are different for both units then one or other of the remote controls will have to be re-programmed. Contact your VTL Dealer or the Factory for a solution to this problem. Note that in either case t…

7, Location and Ventilation Install this preamplifier in a location which is stable and well ventilated. If the preamplifier is placed in a built-in installation, ensure that there is adequate room for a supply of air to flow through the ventilation openings. Allow at least 3 - 5 inches…

18, In this case the output from the tape deck should be connected to the regular line input marked Tape in the main input cluster on the TL2.5. This loud hum will not damage your TL2.5, but may damage other components in the system if sufficiently loud enough. Connecting a s…

24, Plugging in a new tube Consult the figure above to make sure that you are inserting the correct tube type into the correct socket. Hold onto the upper portion of the tube towards its tip. Lower the tube onto the socket, making sure that the pins from the tube matches the ho…