Primex XR Classic Series Installation Manual

8, Parameter Specification Code Blue Timer Input Range 5-120 VAC or DC Code Blue and Elapsed Timer Audible Beep Option Frequency 3KHz +/-0.5KHz ETL Listed Conforms to UL Standard for Safety for Time-Indicating and -Recording Appliances (UL 863, 8th Edition, Date 11/16/2007) NOTE: All specif…

19, Surface-mount Tilt Bracket Mounting Dimensions Figure 15: Single Digital Clock/Timer Mounting Dimensions Illustration NOTE: *D dimension is the mounting screw spacing on the clock/timer. Table 3: Single Digital Clock/Timer Mounting Dimensions Dimension Clock/Timer Model A B C D E F G H…

22, Antenna BNC Cable The clocks/timers with a remote antenna are shipped from the factory with the 4.5 meters (15 foot) BNC cable attached to the clock/timer assembly. l The length of the 4.5 meters (15 feet) cable can be increased by adding cables and adaptors up to a maximum recommended…

10, CONFIGURE DIGITAL CLOCK AND TIMER SETTINGS - CLASSIC SERIES To change the factory default settings, remove the small rectangular access panel located in the upper center of the face of the clock/timer. To aid in removal, there is a small recess in the top center of this panel. The panel can be re…

1, Primex XR Classic Series XR TIME SYNCHORNIZATION XR CLASSIC SERIES DIGITAL CLOCKS/TIMERS INSTALLATION GUIDE Doc Part No.: 140109 04.09.14 …

14, 230 VAC Wiring Specifications All 230 VAC clocks include a 9ʼ cord with a three pin earthed plug. If pigtail/hard wiring is required for the application please refer to 230VAC Digital Clock Wiring. l Receiver Sensitivity (Decode) > 110dBm Surface-mount Installation Complete the instructions bel…