Wacker Neuson BPU 2540A Operator's Manual

8, Wacker Neuson BPU 2540A 2 Safety BPU 8 Operator's manual Checking for signs of damage Inspect the machine when it is switched off for any signs of damage at least once per work shift. Do not operate the machine if there is visible damage or defects. Have any damage or defects eliminated immediately…

14, 2 Safety BPU 14 Operator's manual 2.7 Safety during the operation of combustion engines Checking for signs of damage Check the engine while switched off for leaks and cracks in the fuel line, tank and fuel cap at least once per work shift. Do not operate the machine if there is visible…

24, T00846GB.fm 24 TRANSPORT TO WORK SITE, RECOMMENDATIONS ON COMPACTION Transport to work site Conditions: - To transport the vibration plate, use only suitable lifting equipment with a minimum load-bearing capacity of 250 kg. - Only attach suitable tackle at the central lifting point (…

13, BPU 2 Safety Operator's manual 13 Avoiding crushing When operating the machine, pay particular attention to avoid being squeezed between the machine and an obstacle. Always look in the direction of travel! Compacting on slopes The following points must be observed if you plan to co…

26, T00847GB.fm 26 OPERATION 3. Pull the throttle lever (6) back slightly. 4. Turn the engine switch to the „I“ position. 5. Pull the starter grip lightly until resistance is felt, then pull briskly. Caution: Do not allow the starter grip to snap back against the engine. Return it gently to pre…

25, T00847GB.fm 25 OPERATION Engine check before starting 1. Oil level check Insert dipstick in oil filler neck, but without screwing in. If oil level is low, fill to the top of the oil filler neck with high grade Fuchs Titan Unic 10W40 MC oil. ATTENTION! Place machine in horizontal positi…