Voltronic Power Galleon II 3P Operation & User’s Manual

20, Voltronic Power Galleon II 3P 17 connection. (Normal UPS shutdown means turning off input breaker in bypass/no output mode).  01: Output voltage Interface Setting Parameter 3: Output voltage You may choose the following output voltage in parameter 3: 208: Presents output voltage is …

19, 16 BC The second line CA The third line HS.H Hot Standby 3-7. LCD Setting There are three parameters to set up the UPS. Refer to following diagram. Parameter 1 Parameter 2 Parameter 3 Programs available list for parameter 1: Code Description By…

8, 5 Diagram 3: 30K Rear Panel Diagram 4: 40K Rear Panel Diagram 5: 30KL/ 40KL Diagram 6: 30K/40K Input/output Input/Output Terminal Terminal 1. RS-232 communication port 2. USB communication port 3. Emergency power off function connecto…

18, 15 1) If the bypass is abnormal, you can not remove the UPS without interruption. You must cut off the load and shut down the system first. 2) Make sure the bypass setting is enabled in each UPS and then turn off the running system. All UPSs will transfer to Bypass mode. Remove all the ma…

11, 8 2-4. UPS Installation for Parallel System If the UPS is only available for single operation, you may skip this section to the next. 1) Install and wires the UPSs according to the section 2-3. 2) Connect the output wires of each UPS to an output breaker. 3) Connect all out…