Xyron PRO 2500 Operation & User’s Manual

10, Warranty Information Xyron, Inc. warrants that the XM2500 is free from defects in material and workmanship for a period of one (1) year from the date of purchase. Xyron, Inc. will repair or replace a defective product or part without charge, with proof of purchase. If the produc…

8, When properly used, the XM2500 is relatively maintenance-free. Listed below are safeguards and tips that will produce better results. Importance of a clean document: For best results when laminating, it is highly recommended that the document be cleaned with a soft, lint-free…

4, Step 3: • On the bottom supply roll, grasp the laminated starter section by the leading edge film. • Route over the bottom idler bar adjacent to the lower rubber roller. • Make sure the lm is inserted squarely. Rotate the handle 1/4 turn in the direction of the arrows. …

9, Xyron PRO 2500 TROUBLESHOOTING Symptom Cause Solution Long documents (such as banners) are not aligned with film layers after laminating. Feed Tray not installed correctly or supply roll not seated at base of groove in side plate(s). Verify tray is completely installed such that it is approximately …

2, Upper Idler Bar Upper Supply Roll Rubber Rollers Slots for Supply Installation Lower Access Door Open to install and remove supplies Lower Idler Bar Paddle Used to lock document in place Lower Supply Roll Top Cover Remove to install/remove supplies Crank Handle Used to advance documents an…

5, Step 1: • Pull back on the paddle so that it is in the “up” position. • Insert a document so the leading edge is under the paddle. The document should extend past the edge of the paddle 1-2 inches (2.5-5cm). Note: The side of the document which is face down wil…