BIXOLON SRP-270 Reference Manual

6, POS/Mobile Printer Rev. 1.00 - 6 - 2-3 State (LONG R) This is the property that sets the printer status. It is read only and calls GetStatus() to read the printer status. The status value can be set in duplicate and each value can be checked using bitwise operation. These are the printe…

34, POS/Mobile Printer Rev. 1.00 - 34 - 3-22 NextPrintPos Feed the paper to the starting point of the next label paper. The function is only enabled if the mobile printer is set to label mode. int NextPrintPos() [Parameters] None [Return Values] Constant V…

38, POS/Mobile Printer Rev. 1.00 - 38 - 3-26 SetPrintAreaInPM Sets the size and position of the printing area when set to Page Mode. int SetPrintAreaInPM (long x, Iong y, Iong width, Iong height) [Parameters] * Iong x [in] x-coordinates of the printing area * Iong y [in] y-coordin…

10, POS/Mobile Printer Rev. 1.00 - 10 - 3-4 LineFeed Line feed to the amount of the integer value set as a factor. int LineFeed (const unsigned int lineNum) [Parameters] * const unsigned int lineNum [in] Send the number of line feeding lines in an integer value a…

28, BIXOLON SRP-270 POS/Mobile Printer Rev. 1.00 - 28 - 3-16 RemoveAllNVImage Remove all the images stored in the non-volatile memory area of the printer. int RemoveAllNVImage () [Parameters] None [Return Values] Constant Value Description SUCCESS 0 The function is success…

41, POS/Mobile Printer Rev. 1.00 - 41 - 3-29 SetHorizontalPositionInPM Set the horizontal position for printing. int SetHorizontalPositionInPM (Iong position, bool relative) [Parameters] * long position [in] Starting position to be set * bool relative [in] Set wheth…