Town & Country Fireplaces TC36.NG04D Installation Instructions Manual

20, TC36_NG04D 240317-24 5056.427D4 Figure 42: Removing manifold pressure plug. Figure 43: Adjusting manifold pressure. SUPPLY PRESSURE MANIFOLD PRESSURE Figure 44: Gas test ports. 20 Note: To test the gas pressure, turn off the gas supply before removing the plug from the supply …

5, Town & Country Fireplaces TC36.NG04D Figure 7: Left hand side cover. Figure 8: Right hand side cover. 5 TC36_NG04D 240317-24 5056.427D4 6. Place side covers between the burner tray and its base (Figure 7 and Figure 8) before the burner tray is inserted into the rebox. These will remain in the retracted position until…

16, TC36_NG04D 240317-24 5056.427D4 16 Pilot gas supply connection Ignition and sensor wires Main gas supply connection (Do not disconnect) Figure 29: Connections at bulkhead. Ignition wire (red) Flame sensor wire (white) Interface module Figure 30: Disconnecting ame sensor and ignition wire…

2, TC36_NG04D 240317-24 5056.427D4 2 Contents of Package A. Burner assembly (including pilot & gas lines) B. Panel, base (attached to burner assembly). C. Pebble assembly D. Hardware - tapered plugs, screws, brush, panel clips. E. Side cover - left hand side. F. 2.2 lbs Sand G. Side c…

8, TC36_NG04D 240317-24 5056.427D4 8 Ignition wire (red) Flame sensor wire (white) Interface module Figure 14: Interface module. 12. Attach the ignition and sensor wires to the interface module as indicated in Figure 14. 13. Once the gas and electrical lines are connected to the bulkhead and…

13, Figure 24: Applying sand to burner tray. This rock covers pilot Figure 25: Tranquility rock set 13 TC36_NG04D 240317-24 5056.427D4 25. Remove tapered plugs from ports. 26. Remove pebble assembly from packaging by placing hand on top and tipping upside down. Note that the rock …