A-Neu Video ANI-1082UHD Instruction Manual

10, 8 REAR & SIDE PANEL REAR PANEL a CAT AUDIO I/O 1~2: Sends/receives audio to/from connected compatible CAT Audio devices via a standard CAT5e cable. This connection allows audio to be sent to/from the matrix over greater distances than would normally be possible via standard cables. …

28, WebGUI Control Zone Audio Audio Output Setting Click the “edit” icon ( ) to change the following settings: Rename: The Zone Audio outputs can be renamed here. Volume: Adjustable from -100dB to 0dB. Bass: Adjustable from -12dB to +12dB. Treble: Adjustable from -12dB to +12dB. Delay: A…

17, 15 RS-232 & TELNET COMMANDS Full Command List COMMAND DESCRIPTION ExtLineOut M Name={NameString} Sets the verbose name of an extended line output. Maximum 32 characters. M = 1~4 NOTE: Can only rename one port at a time. Multi-port is not supported. AudioCAT_Out M AudioSrc=XXX Sets the a…

36, A-Neu Video ANI-1082UHD WebGUI Control EDID Settings Set EDID Input Content The Set EDID Input Content section allows for the assignment of an EDID to each individual input port, or to all inputs at once. Click the selection bar to toggle between individual assignment, or all inputs. The unit comes with the following …

8, 6 FRONT PANEL RECEIVER Front Panel q POWER LED: This power LED will illuminate when receiving power from the transmitter. w OPTICAL IN: Connects with an optical audio source as an optical audio return which sends audio back to the ANI-1082UHD. e IR IN 1: IR IN 1 is considered a…

7, 5 FRONT PANEL FRONT PANEL q POWER: Press this button to power the unit on or place it into standby mode. NOTE: Network functionality and PoH (if the second power supply is connected) remains active when the unit is in stand-by mode. w POWER LED: This LED will illuminate GREEN to indicate…