Advanced Power technologies TTC-1000 Instruction & Operation Manual

116, 107 V6.70 20131017 6. Even if the HyperAccess transfer times out, continue with the procedure up until the transfer progress dialog box appears. This will save your settings as far as proto col and directory so that it will not need to be re - entered, thus speeding up the process…

76, 67 V6.70 20131017 Kk 2 /0/1/n where kk 2 =Parameter # and n=1,2,3,4,5,6 Use the INVERT OUTn setting to cause the output relay to drop out when either temperature set point is achi eved. The resulting Boolean equation is: OUT n = !(Temperature Set Point kp1 + Temperature…

161, 152 V6.70 20131017 Setting # Setting Purpose Setting Range or Values Program to 68 IN10 NONINVERT or INVERT Sets if input is picked up (NONINVERT) or dropped out (INVERT) when energized 68 /0: NONINVERT 68 /1: INVERT SET ONLY IF Optically Isolated Inputs avai…

45, 36 V6.70 20131017 The steady state winding temperature is calculated based on the following equation 1 : TO m n n n n g HS RatedLoad CRatio Load fl) n       2 ) / * ( * ( [1] Where: n = 1, 2, 3 perature windng tem alculated Ulti…

189, Advanced Power technologies TTC-1000 180 V6.70 20131017 Input Register 6 Measured Load Current 1 (fixed binary point number, upper byte - whole part, lower byte – fractional part, Amps) Input Register 7 Measured Load Current 2 Input Register 8 Measured Load Current 3 Input Register 9 Measured Load Curren…

6, Table of Contents v V6.70 20131017 11.4.5 Add or Delete Load1 From Log ................................ ................... 114 11.5 Viewin g the Data Log ................................ ................................ ......... 115 11.6 Saving Data Log as Comma Delimited F…