AGA DC3 User's Manual & Installation Instructions

22, 18 Consumer protection As a responsible manufacturer, we take care to make sure that our products are designed and constructed to meet the required safety standards when properly installed and used. CAUTION: THIS INSTALLATION MUST MEET THE REQUIREMENTS OF AS/NZS 5601, AND MUST CONFORM WITH LO…

40, 36 DESN 511617 REMOVAL OF HOTPLATE 1. Repeat operations in REMOVAL OF TOP PLATE’. 2. Remove burner heads and burner caps. 3. Remove all of the screws retaining hotplate burner trims (4 from the Wok burner, 2 each from the other three burners). (Fig. 19.2). 4. Carefully remove burn…

25, 21 K POSITION OF LIDS WHEN RAISED A **O H J G B C E **N L D F OVEN DOOR IN OPEN POSITION PLAN VIEW FRONT VIEW LEFT-HAND SIDE VIEW RIGHT-HAND SIDE VIEW HOTCUPBOARD ELECTRICITY SUPPLY MINIMUM WALL POSITION DESN 516862 A NOTE: When surveying for the installation the actual clearance required f…

48, With AGA Rangemaster’s policy of continuous product improvement, the Company reserves the right to change specications and make modications to the appliances described and illustrated at any time. www.agaliving.com www.agacookshop.co.uk Manufactured By AGA Rangemaster Stati…

18, AGA DC3 14 BURNER CAP RETAINING LUGS DESN 513513 Fig. 6.1 Gas hotplate  If spillage does occur on a burner cap or pan support, move pan to another burner and when cool, clean in hot soapy water.  After cleaning, be sure all parts are dry. When tting the burner cap and burner head, mak…

41, 37 TO CHANGE IGNITION GENERATOR 1. Turn o electricity supply. 2. Remove top plate and hotplate (See REMOVAL OF TOP PLATE and REMOVAL OF HOTPLATE). 3. Remove two screws retaining the generator xing bracket to the burner mounting panel, and remove generator (Fig. 19.5). 4.…