Baldor MotiFlex e100 Installation Manual

59, www.baldormotion.com Basic Installation 3-43MN1943 3.9.7 Duty cycle The regeneration duty cycle is the amount of time taken regenerating as a proportion of the overall application cycle time. For example, Figure 25 shows a system which performs a trapezoidal move profile, with regene…

43, www.baldormotion.com Basic Installation 3-27MN1943 3.6.2 24 VDC control circuit backup supply wiring When multiple MotiFlex e100 are mounted side-by-side for DC bus sharing (see section 3.5), the 24 VDC backup supply wiring can be reduced. A channel and supporting tabs are built-in to the front pan…

41, www.baldormotion.com Basic Installation 3-25MN1943 3.5.3 Line reactors When a drive is sharing its DC bus, a line reactor must be fitted. This should be connected between the source drive’s fuse (or circuit breaker) and the AC input filter (see Figure 8 on page 3-17). See section A.1.3 for fur…

22, Baldor MotiFlex e100 www.baldormotion.com 3-6 Basic Installation MN1943 3.2.3 Dimensions - 48 A ~ 65 A models 212 (8.35) 92.5 (3.64) 350 (13.78) 362 (14.25) 6 (0.24) 13.5 (0.53) Mounting hol e and slot detail Dimensions s hown as: mm (inches ) Depth: 260 mm (10.24 in) Weight: 48 A: 12.45 k g (27.4 lb) 65 A: 12.45 k…

31, www.baldormotion.com Basic Installation 3-15MN1943 3.4.2 AC input and regeneration resistor output wiring The installation methods shown in Figure 7 will improve the reliability of the system, reduce troubleshooting time, and optimize the EMC (electromagnetic compatibility) behavi…