Amano CP-3000 Operation & User’s Manual

38, 4-8 CP-3000 User’s Guide Note: After saving the date, the LED indicator on the front panel will automatically adjust to the correct day of the week when switched to NORMAL. Hours and Minutes Note: To set the hours and minutes, you must cycle through the following sequence of …

27, CP-3000 User’s Guide 3-5 Bottom Margin (Bm) Adjustment Step 1. If you have not already done so, enter theProgram Mode and press the FUNCTION key until the Time Card menu item appears in the display. Step 2. Press the NO key to select the Bottom Margin Adjustment Pass…

45, Amano CP-3000 CP-3000 User’s Guide 4-15 Step 13. When the desired value appears, press the YES key. The display will automatically move to the Additional Date Imprint menu item. Step 14. Press the NO key to select a value of “0” to disable this feature or “1” to include an additi…

61, CP-3000 User’s Guide 6-5 Weekly Program Possible reasons for this error message are: The time card setting has been changed in Program Mode. Duplicate times have been scheduled in the Weekly Program. You must perform a Reset (Clear All) to reset to the default card type …

31, CP-3000 User’s Guide 4-1 Chapter 4: Programming Introduction The CP-3000 must be programmed before use. There are two types of programming: Basic and Weekly. Basic Programming is used to program basic clock functions such as time, date, time display, Daylight Saving Time (DST) adju…

50, 4-20 CP-3000 User’s Guide Step 5. If you have programmed one or more Weekly Programs, insert another time card (or the reverse side of the one used in step 4) to obtain a printout. Up to sixteen Weekly Programs are printed on a card. Step 6. To stop printing at any …