Bentel Omnia Installation Manual

27, Connecting Signalling devices Alarm signalling devices such as: Self-powered sirens, Indoor sirens and Telephone diallers are classified as fol- lows.  Intrinsic security devices (e.g. Self-powered sirens----see Figure 18) will be activated by voltage failure on the alarm terminal.  Po…

44, Bentel Omnia + Protocols with Voice management transmit one event per call, therefore, they should be used for events that do not require a voice channel. The same protocol----without Voice management----can be programmed for these events, as follows:  assign the Central Station telephone n…

71, OmniaTIMER The OmniaTIMER board must be connected to the Main unit serial port----which is duplicated on the interface. The OmniaTIMER interface allows direct connection to a serial or parallel printer----for real-time printout of events, and entire Event buffer printout. The on-board Schedul…

83, Disarming under duress The connections and programming described in this section will allow the user to disarm the system and, at the same time, send a Disarming under duress event to the central station. Solution no. 1 Program two codes for partition disarming----the first for…

47, Event-Actions The Events-Actions page is the core of the System. The Panel will operate in accordance with the programming done in this page. Events Table The Output, Digital Communicator and Dialler Actions can be assigned to the Events shown. The Events Table is set out in t…

63, Remote Downloading from computer The Panel can be programmed through the B-MODor B-MOD/RX modem. + The Teleservice option must be enabled by the User (refer to Enable/Disable Teleservice section in the USER MANUAL). Step 1 Connect the modem to the computer serial port by means of the serial cable…