Bungard FilmStar-PLUS User Manual Manual

8, Photoplotter FilmStar-PLUS Instructions to Use Page 8 / 16 take the flexible hose from the holder, close the opening by your thumb, put the end over the container where you want to drain the liquid in and release the thumb. Wash all tanks with water and make sure there are no residues sitting…

6, Photoplotter FilmStar-PLUS Instructions to Use Page 6 / 16 Test run You will need some adhesive tape to mount the film on the drum. We suggest you use 20mm white paper tape (painter's utilities), as this white tape can be best seen in the Dark Room light and it can easily b…

15, Photoplotter FilmStar-PLUS Instructions to Use Page 15 / 16 If you need the laser intensity for only one resolu- tion, choose Tools – Plot Lightbar. In the upcom- ing menu you need to select the desired resolu- tion, the start intensity of the test row (First Light) and the …

4, Bungard FilmStar-PLUS Photoplotter FilmStar-PLUS Instructions to Use Page 4 / 16 Setup – Short Instructions Remove Filmstar-PLUS from the packaging and inspect for transport damages. Set up Dark Room (no light may penetrate from the outside!). Install and connect the special safelight. Place plotte…

11, Photoplotter FilmStar-PLUS Instructions to Use Page 11 / 16 The name of the aperture file will show in the column right to the one with the name of the Gerber file. Each Gerber file needs its own aperture table. If a Gerber image was removed from the plot area, the associate ap…

10, Photoplotter FilmStar-PLUS Instructions to Use Page 10 / 16 Some programming reasons require that the assignment of the X and Y axes on the screen look different than on the photoplotter: The plot image is both mirrored and twisted by 90 degrees. That causes that the d…