Camco 43421 Installation Instructions Manual

7, Camco Mfg. Inc. 121 Landmark Drive Greensboro, NC 27409 #303 z895231 TEMPLATE #2 2-3/8" USE THIS TEMPLATE FOR CABINETS WITH NO OVERHANG. SEE INSTRUCTION BOOKLET FOR COMPLETE DETAILS. 1. Carefully use nail or pen to poke through both circles (Figure M in instruction booklet). 2.…

3, Camco 43421 3 Section A - Countertops with Overhang (continued)            countertop (Figure I     �…

6, Camco Mfg. Inc. 121 Landmark Drive Greensboro, NC 27409 #403 z895216 TEMPLATE #1 USE THIS TEMPLATE FOR CABINETS WITH OVERHANG. SEE INSTRUCTION BOOKLET FOR COMPLETE DETAILS. 1. Measure overhang with OVERHANG MEASUREMENT TOOL. 2. Match corresponding letter on overhang measurement tool w…

1, 1. Using enclosed Overhang Measurement Tool, measure counter overhang in center of location where you plan to mount extension. Place overhang tool under overhang with dimension lines facing upward. Slide tool forward under overhang until it touches cabinet side (Figure A). Note which line …

2, 3. Locate Template #1 and find proper hole set by matching letter from Overhang Measurement Tool (see Step 1). For example: If overhang is 7/8"; corresponding letter is “C”—use holes aligned with “C” on Template #1. With a nail or pen, carefully punch through both correspond…