AMD GA-M55S-S3 Operation & User’s Manual

39, BIOS Setup- 39 - English ECP Mode Use DMA This item will become available when Parallel Port Mode set to ECP or ECP+EPP. 3 Set ECP Mode Use DMA to 3. (Default value) 1 Set ECP Mode Use DMA to 1. On-Chip USB V1.1+V2.0 Enable USB 1.1 and USB 2.0 controllers. (Default value) V1.1 Enable only USB 1.1 co…

76, GA-M55S-S3 Motherboard - 76 - English After the SATA controller driver installation is completed, you can proceed with the Windows 2000/XP installation. Figure 18 (Note: Each time you add a new hard drive to a RAID array, the RAID driver will have to be installed under Windows once for…

45, BIOS Setup- 45 - English 2-7 MB Intelligent Tweaker(M.I.T.) CPU Frequency (MHz) 200 ~ 500 Set CPU Frequency from 200MHz to 500MHz. (Default value: Auto) PCIE Clock (MHz) 100 ~ 200 Set PCIE Clock from 100MHz to 200MHz. (Default value: Auto) CPU Clock Ratio This setup option will automat…

67, Appendix- 67 - English (Note) Skip this step if you do not want to create RAID array on the SATA controller. To configure SATA hard drive(s), follow the steps below: (1) Install SATA hard drive(s) in your system. (2) Configure SATA controller mode and boot sequence in BIOS Setup. (3) Confi…

26, AMD GA-M55S-S3 GA-M55S-S3 Motherboard - 26 - English 16) F_ USB1 / F_USB2 / F_USB3 (Front USB Connector) Be careful with the polarity of the front USB connector. Check the pin assignment carefully while you connect the front USB cable, incorrect connection between the cable and connector will make …

49, BIOS Setup- 49 - English 2-11 Save & Exit Setup Type "Y" will quit the Setup Utility and save the user setup value to RTC CMOS. Type "N" will return to Setup Utility. 2-12 Exit Without Saving Type "Y" will quit the Setup Utility without saving to RTC…