Coemar LEDko D Instruction Manual

14, 14 Warning! Make sure that screening and conductors are not in contact one another or with the metal housing of the connector. Pin#1 and housing must never be connected to the power supply unit. 6.1 Control signal connection by XLR5 plugs The digital control signal is transmitted to the project…

15, Coemar LEDko D 15 A00 1 7. Turning on the projector After having followed the preceding steps described, proceed with the power supply and turn on the projector connecting it to the mains power. The software version installed on the internal microprocessors will be shown on the displa…

5, 5 Congratulations on having purchased a Coemar product. You have assured yourself of a fixture of the highest quality, both in componentry and in the technology used. We renew our invitation to you to complete the service information on the previous page, to expedite any request for se…

9, 9 3.4 Back panel description Display Menu button Enter button PowerCon In PowerCon Out Plus button Minus button DMX In DMX Out …

26, 26 11. Maintenance 11.1 Firmware update The firmware of LEDko T/D can be updates through the RDM protocol (ANSI E1.20). Contact Coemar assistance to receive the software and the device updater. 11.2 Periodic cleaning Lenses Even a thin layer of dust can reduce the luminous o…

21, 21 LED: Shows the percentage value of the LED status. Fre: Shows the operating frequency of the LED (611 Hz as default). Fan speed: Shows the percentage fan usage. Usage hours: Shows the hour counter of the fixture: • Unit: shows the overall hours of life of the fixture; • LED life…