d&b audiotechnik D6 Software Manual

8, 2.5 Settings menu Settings Id0.01 Back Input analog Ch A Q7 Ch B Q-SUB off Remote off Lock Press 2s Options Fig. 3: Settings menu The Settings menu contains general settings for the device and gives further access to submenus. In…

13, System Check System Check System Check is a powerful and convenient tool to check the condition of either a single d&b loudspeaker or a complete d&b sound system driven by the D6. It is preferably used in conjunction with the d&b Remote network and the R1 software. S…

26, Power Supply Back Mains 230V Frequency 50Hz Mains The currently measured mains voltage to which the device is connected in volts. The typical accuracy is 2 %. Frequency The detected mains frequency. Buzzer off Buzzer An additional acoustical signal f…

15, Load Monitoring A Back Mode off Detection Time 99s Detection Time 1s Detection Time 99s Load Monitoring menu Mode Selecting "Mode" within the "Load Monitoring menu" and pushing the encoder activates "Load Monitoring"…

3, Contents 1. Introduction......................................................................4 1.1 Block diagram of the DSP software......................................................4 2. The D6 operating software.............................................5 2.1 Menu tree.......................…

18, d&b audiotechnik D6 AmpPreset Last 1 * Back Select 9 MyPreset Load Save Clear Ok? Select Turning and pushing the encoder provides access to the nine user preset memories to be loaded, saved or cleared. To load, save or clear the selected Preset first scroll to the respective menu i…