American DJ Arcbeam 150 Instructions Manual

3, American DJ ® User Instructions Connect the DMX out (the socket) on the first unit (master) to the second unit (slave) using a balanced XLR lead. Repeat this connection for all units. Note: If the Strobetec™ is being connected in a master/slave with StarTec™ H150 or St…

2, American DJ Arcbeam 150 Front panel features 1. DMX output socket (pin 3 hot, pin 2 cold, pin 1 grounded). Other DMX devices can be linked in to the system through this socket. In stand alone mode the unit outputs its own DMX through this socket. 2. DMX input plug (pin 3 hot, pin 2 cold, pin 1 grounded).…

7, DMX implementation - Using any standard U.S.I.T.T. DMX Control Board. Mirror Pan (Channel 0) - Looking into mirror Mirror Tilt (Channel 1) - Looking into mirror Color (Channel 2) Gobo (Channel 3) Note: Gobo controller …

8, American DJ ® User Instructions Standard DMX-512 Dipswitch Setting Codes Follow the procedure below to set dipswitches to certain channels. Dip switch 1 adds 1 to the channel number when turned ‘on’ Dip switch 2 adds 2 channels Dip switch 3 adds 4 channels Di…

6, American DJ ® User Instructions If you have problems (‘trouble shooting’) Listed below is a few common problems the user may encounter, with solutions. No light from the unit. Check if the ‘Power On’ (red) LED is lit and the fan is running. If not there is no main supply.…

5, American DJ ® User Instructions which the unit will begin to respond to DMX input, or to sound if no DMX is connected. The unit will not turn on its lamp until after initialization, and then only if its control channels are not all at zero. Unit in stand alone mode If …