DPS Telecom NetGuardian 832A G5 Operation & User’s Manual

52, 46 3. Type the default password, "dpstelecom," then press Enter. Note: DPS strongly recommends changing the default password. 4. The NetGuardian's main menu will appear. 5. Type C for the C)onfig menu. 6. Type E for E)dit menu. 7. Type E for port settings, 1 for Net 1 and 2…

1, DPS Telecom NetGuardian 832A G5 USER MANUAL NetGuardian 832A & 864A G5 February 26, 2010 D-OC-UM102.26100 Firmware Version 5.2D Visit our website at www.dpstelecom.com for the latest PDF manual and FAQs. …

42, 36 Fig. 6.14.2. Jumper settings for analog alarm inputs and control relays For control relay jumpers, the open position corresponds to normally open operation, and the closed position corresponds to normally closed operation. See Figure 6.14.2. Note: Default settings may be differ…

36, 30 Fig. 6.12.2. 66 Block connections for Discretes 49–64, Relays 1–8, and Analogs 1–6 RTN* is the alarm return pin. Alarms on standard units are dry closure or ground closure. Most units will have RTN internally tied to GND. However, special hardware assemblies may have RTN isolated f…

81, 75 SNMP FAQs15.2 Q. How do I configure the NetGuardian to send traps to an SNMP manager? Is there a separate MIB for the NetGuardian? How many SNMP managers can the agent send traps to? And how do I set the IP address of the SNMP manager and the community string to be used when se…