Duplo 660P Maintenance Manual

40, Duplo 660P How To Replace The Knife Cutting Line Light 1) Take top front cover off 2) Loosen the bolt and pull the light away from the mounting bracket 3) Disconnect the male from the female connector and remove the 2 phillip screws from the mounting bracket and take …

23, SECTION 5 - ELECTRICAL DESCRIPTION & ADJUSTMENTS SETUP FOR PROGRAMMATIC MARK II The 660P paper cutter is controlled by the Programmatic Mark II controller. Use the following procedure to make changes or verify settings in the Programmatic Mark II controller. Note: the…

22, SECTION 5 - ELECTRICAL & ELECTRICAL ADJUSTMENTS START UP AND SHUT DOWN PROCEDURE The paper cutter is designed to calibrate itself each time it is turned on (It also can automatically calibrate after a given number of cutting cycles - see item number 4). Do not turn off th…

50, NOTE: New Light Safety Curtain for 660 Cutter The new light safety curtain will not work the older machines, because they do not have a AC 24 V power wire fitted, if you would like to mount the new light safety curtain on t…

35, Installation Check List 1) Check voltage on the machine after electrical wiring is done by checking the T and L on the terminal board to see if it is between 208v -232v, if not you will have to install a buck booster transformer 2) Turn…

37, How To Adjust The Full Maximum Paper Cutting Ability Take a full stack of heavy paper stock and place it into the cutter and make a cut, if it cuts all the way thought then you are ok, but if does not cut all the way thought then you have to do the following: 1) T…