American DJ Show Designer Instruction Manual

5, American DJ Show Designer 4 the attribute you are changing. Finally you must always press “Enter” to record any changes you make to any attribute. The message “DONE” will appear in the display when the change has been recorded. NAME is the fixture name that appears whenever you select or deselect a fixture. You may w…

2, 1 OVERVIEW Show Designer is a new lighting controller designed to control the many intelligent moving stage lights that are now available. The approach of this controller is to try to simplify the programming process as much as possible while still offering a high level of control at a low cost.…

1, American DJ® Show Designer Software Revision 2.08 American DJ 4295 Charter Street Los Angeles, CA 90058 USA E-mail: [email protected] Web: www.americandj.com …

9, 8 move the pan or tilt using the smallest possible steps for any selected fixture. When fine is not on, pan or tilt will increment or decrement in steps of 5 for fixtures that use 1 channel for pan or tilt or control the coarse channel for fixtures that use a coarse and fine channel for pan or ti…

12, 11 RECALLING PRESETS To add a preset to the current scene on stage, first select the fixtures that you want to control with the preset. Next, press the “Color” or “Beam” switch, select the page of the desired preset then use the number switches to select 1 of 16 presets on that page. Unlike …

14, 13 Note: It can take up to 30 seconds to overwrite or erase a chase depending on how much of the memory is currently filled. After you have stored the chase, Show Designer remains in chase record mode allowing you to continue to edit the chase. To exit record mode, press “Record�…