ELPRO EL-MX-B004 Owner's Manual

31, 31 Return to Modification page you will see the output have been changed Touch brown block to modify input name and icon Input the name and select the icon you prefer then touch「Save」to finish Return…

16, 16 5.0 Remote Control Function ( IR01): 5.1 To command the matrix locally, setup the remote control IR01 ID with the same code of the Matrix (see 4.6). The default code is 4. (Power+4) 5.2 To command from remote HDBaseT output which input port must be routed on the ou…

8, ELPRO EL-MX-B004 8 4.3 IR TX (From matrix to remote locations) : (Default IR TX: O O O O) This function setup the IR signal whether from MATRIX, by IR Rx input jack, is sent to HDBaseT ports. Setting O the transmission is enabled, setting X transmission is off. This is the typi…

5, 5 3.3 LCM Panel Function: Power on Main Screen When the power is on and the main screen appears Channel Setting on Main Screen The Matrix will jump to channel setting screen after 10 seconds, press the MENU key to enter the main Main MENU Option: *1. SWITCH *2. R…

29, 29 Modify Device Press the matrix name to show pop-up dialog Touch「Modification」to enter modification page. Yellow block shows matrix name and icon Green block shows name and icon of output devices Brown b…

43, 43 Return to Modification page you will see the matrix have been changed Touch green block to modify output name and icon Input the name and select the icon you prefer then touch「Save」to finish Return to M…