EMKO EZM-4430 Instruction Manual

30, 30 Upcount on rising edge of Ch-A input Upcount on rising edge of Ch-B input Start Value = 0 Start Value = 8 Counting to upwards Counting to downwards Value on the Screen Upcount on rising edge of Ch-A input when Ch-B is at 0 Downcount on rising edge of Ch-A when Ch-B is at 1 Ch-A St…

6, 6 1.2 Ordering Information EzM-4430 ( 48x48 DIN 1/16) A BC D E FG HI / / U V W Z/ / All order information of EZM-4430 Programmable Counter are given on the table at left. User may form appropriate device configuration from information and codes that at the table and convert it t…

39, When count value reaches the SET Value, Output Position is changed. If Output Pulse time is not 0, then Output Position is changed the old position at the end of the Pulse time. Count value starts counting from 0 value. But SET value is observed in actual value dis…

22, 22 4.3 Adjustment of SET Value Changing SET Value O1 O2 SV S2 Counter O1 O2 SV S2 Counter RESET P SET RESET P SET Operation Screen SET Screen When shift button is pressed, 6th digit of SET value starts to flash. Press Shift button again. Increase the flashing value with increment button…

36, 36 Automatic Reset-1 Counting direction : 0 --> P (Upcounting) = 0 Set Reset Output Output = = When count value reaches the Set Value, Output Position is changed. Actual value is reset automatically. Counting starts upcounting from 0 value. If Output Pulse time is not …

48, EMKO EZM-4430 48 Installation : Fixed installation Over Voltage Category : II Pollution Degree : II, office or workplace, none conductive pollution Operating Conditions : Continuous Supply Voltage and Power : 230 V V (-%15 / +%10) 50/60 Hz. 2.3VA 115 V V (-%15 / +%10) 50/60 Hz. 2.3VA 24 V V…