Empress Effects buffer plus Operation & User’s Manual

19, Empress Effects buffer plus - The AB position of the stomp function toggle switch is not used. - Both noise filters must be set the same for effective noise filtering. Mode 12 (boost at amp's FX loop return) This mode functions exactly the same as Mode 11, with the only difference being that the …

8, Mode 1 - Un-summed Loop Ins This is the standard operating mode for a stereo setup. In this mode, loop in 1 and loop in 2 are sent to out 1 and out 2 respectively. A wet/dry rig can be created by using a mono effects chain returning to loop in 1 and leaving in 2 and loop in 2 disconnected. …

3, tuner out loop out 1 in 2 in 1 out 1 out 2 loading buffer buffer buffer buffer LED Meter LED Meter LED Meter LED Meter input pad input pad pre- emphasis noise filter pre- emphasis noise filter de- emphasis noise filter de- emphasis noise filter boost boost isolation x-former summing loop in 1 …

11, Mode 4 - Unsummed/Summed Loop Ins Combination In this mode, when the stomp function toggle switch is set to AY, in the A state, loop in 1 and loop in 2 are summed and sent to out 1. In the Y state, loop in 1 and loop in 2 are sent to out 1 and out 2 respectively, and are therefore not summe…

16, Mode 9 - Instrument Select, stereo return and un-summed Loops This mode allows you to have two separate instruments plugged into in 1 and in 2, and use the stomp switch to toggle between them. In this mode, loop in 1 and loop in 2 are sent to out 1 and out 2 respectively, and are not sum…