Endless Pools Swim Spa Operation And Maintenance Manual

9, Endless Pools Swim Spa HEATER CONTROLLER Connections simply snap into appropriate color coded receptacles. TYPICAL SETTINGS Set Point : 59°F to 104°F / Factory set at 84°F Filter Cycle Duration: 0 to 24 hrs / Factory set at 24 hrs Jet Pump Run Time: 1 to 255 min. / Factory set at 30 min. Light Timeout: 1 to 255 mi…

7, 6 DRAINING YOUR ENDLESS POOL SWIM SPA 1) Disconnect electrical power to all pool equipment. 2) Begin to drain down pool water by placing a suitable sump pump in the pool, or by setting up a siphon using a garden hose. If using a siphon, two or more hoses may be used simultane- ously in o…

11, 10 TROUBLESHOOTING Hr An internal hardware error has been detected in in.xe. Contact Customer Service. HL The system has shut the heater down because the temperature at the heater has reached 119°F (48°C). Do not enter the water! Remove the spa cover and allow the water to cool d…

3, 2 Common sense should prevail. • Never use the swim spa when you are alone. • One (1) individual must assume the responsibility for super- vising the swim spa. • Never use the swim spa while or after using narcotics or other drugs that may cause sleepiness, drowsiness or raise/lower blood …

5, 4 The pH will change slowly over the course of a week or two. The number of bathers and the type of chlorine used are just two fac- tors that will cause the pH to change. For this reason, pH should be tested three times a week and adjusted as needed. See the “Maintenance and Use of your Endless…