Hameg HM2005-2 Operation & User’s Manual

26, 26 Subject to change without notice Controls and Readout 10.1.2 Y-position of 2 nd time base B (TRACE SEP); channel 2 The POSITION 2 control will assume the function of Y-position control of the channel 2 signal displayed by time base B in alternate time base mode after the following proc…

17, 17 Subject to change without notice Frame sync pulse triggering Remark: Using frame sync triggering in dual trace chopped mode may result in interference, then the dual trace alternate mode should be chosen. It may also be necessary to turn the read- out off. In order to achie…

15, 15 Subject to change without notice 5 3 ϕ° = — · 360° = — · 360° = 108° T 10 or in angular units: t 3 arc ϕ° = — · 2π = — · 2π = 1,885 rad T 10 Very small phase differences with moderately high frequencies may yield better results with …

16, 16 Subject to change without notice Automatic triggering initiates a new time base start at the end of each sweep, and after the hold off time has elapsed; even without any input signal. Thus there is always a visible trace. The position of the trace(s) without any signal is then given by …

34, 34 Subject to change without notice Controls and Readout 29.1.3 50Ω / 1 MΩ Input Impedance This function allows you to select the input impedance of chan- nel 2. For measurement of low and high frequencies, voltages at sources with impedances deviating from 50Ω an impedance setting of 1 …

33, Hameg HM2005-2 33 Subject to change without notice Controls and Readout button illuminated. The INTENS knob 2 then can be used for manual selecting the dividing ratio of the applied probe. If no probe is applied “*1” should be selected. 28 VERT/XY (pushbutton) This pushbuttones…