HDView360 MINI-STATE HDMS 9100 Operation & User’s Manual

1, HDView360 MINI-STATE HDMS 9100 WARNING: INSTALLATION OF THIS PRODUCT NEAR POWERLINES IS DANGEROUS. FOR YOUR SAFETY, FOLLOW THE INSTALLATION DIRECTIONS. Before Installation Note: to CATV SYSTEM INSTALLER—Article 820-40 of the NEC specied that the cable ground shall be connected to the grounding system of the building…

7, Do not service this product yourself, as opening or removing covers may expose you to dangerous voltage or other hazards. Refer all servicing to qualied service personnel. Available Parts: 5MS9000 Hand Control, 5MS9000 Power Supply, 5MS9000IRK Infrared Conversion Kit, 5MS9000 RV/Boat…

4, Note: Connect all wires and coax before plugging in the receiver, so that the system can detect the antenna’s position and rotate it accurately. The coaxial cable provides feedback from your antenna. If it has not been connected, your receiver may be per- manently dam…

3, 1. Loosen the two screws on the terminal board cover on the bottom of the antenna. This will expose a threaded coaxial receptacle and three special screw-type terminals. 2. Screw the supplied coaxial cable’s lead-in connector onto the threaded terminal. Caution: Be sure the center conduct…

2, 1. READ INSTRUCTIONS—All the safety and operating instruc- tions should be read before the appliance is operated. 2. RETAIN INSTRUCTIONS—The safety and operating instruc- tions should be retained for future reference. 3. HEED WARNING—All warnings on the appliance and in the …