Hirschmann RS20 Programming Manual

102, Rapid Spanning Tree 102 6.6 The Rapid Spanning Tree Protocol Redundanz L2P Release 5.0 04/09 Parameter Meaning Value range Default setting Priority The priority and the MAC address go together to make up the bridge identification. 0 < n*4,096 < 61,440 32.768 Hello Time The left …

100, Rapid Spanning Tree 100 6.6 The Rapid Spanning Tree Protocol Redundanz L2P Release 5.0 04/09 Figure 51: Operation on/off  You now connect the redundant lines.  Define the desired Switch as the root Switch by assigning it the lowest priority in the bridge information among all the S…

45, Sub-Ring (RSR20, RSR30, MACH1000) Redundanz L2P Release 5.0 04/09 4.1 Example configuration 45 4.1 Example configuration The following section shows in detail the configuration of a simple Sub-Ring example. 4.1.1 Example description You want to couple a new network segment with 3 devic…

69, Ring/Network coupling Redundanz L2P Release 5.0 04/09 5.2 Preparing a Ring/Network coupling 69 Note: Configure the coupling port and the redundancy ring ports on different ports.  Select two-Switch redundant coupling (see fig. 33). Figure 32: Two-Switch coupling 1: Coupling port …

77, Hirschmann RS20 Ring/Network coupling Redundanz L2P Release 5.0 04/09 5.2 Preparing a Ring/Network coupling 77 Note: Configure the coupling port and the redundancy ring ports on different ports. Note: If VLANS are configured, note the VLAN configuration of the coupling and partner coupling ports…

98, Rapid Spanning Tree 98 6.6 The Rapid Spanning Tree Protocol Redundanz L2P Release 5.0 04/09 X Bridge identifier of the root bridges X Root path costs for the sending bridges X Bridge identifier for the sending bridges X Port identifiers of the ports through which the message was sent X Por…