Hirschmann RS20 Operation & User’s Manual

22, Ring Redundancy 22 2.2 Example of an MRP-Ring Redundancy Release 6.0 07/2010 Note: For devices with DIP switches, put all DIP switches to “On”. The effect of this is that you can use the software configuration to configure the redundancy function without any restrictions. You th…

70, Spanning Tree 70 4.7 Combining RSTP and MRP Redundancy Release 6.0 07/2010 4.7.1 Application example for the combination of RSTP and MRP The figure (see fig. 27) shows an example for the combination of RSTP and MRP. Prerequisities for further configuration: X You have configured the MRP se…

52, Spanning Tree 52 4.5 Example of Tree Structure Mani- pulation Redundancy Release 6.0 07/2010 4.5 Example of Tree Structure Manipulation The Management Administrator soon discovers that this configuration with bridge 1 as the root bridge (see on page 10 „Example of Root Path D…

39, Hirschmann RS20 Spanning Tree Redundancy L2B Release 6.0 07/2010 3.1 Sub-Ring 39 4 Spanning Tree Note: The Spanning Tree Protocol is a protocol for MAC bridges. For this reason, the following description employs the term bridge for Switch. Local networks are getting bigger and bigger. This applies to bot…

17, Ring Redundancy Redundancy L2B Release 6.0 07/2010 2.1 Example of a HIPER-Ring 17 2.1.1 Setting up and configuring the HIPER-Ring  Set up the network to meet your demands.  You configure all 6 ports so that the transmission speed and the duplex settings of the lines corre…

43, Spanning Tree Redundancy L2B Release 6.0 07/2010 4.1 The Spanning Tree Protocol 43 4.1.4 Root Path Cost Each path that connects 2 bridges is assigned a cost for the transmission (path cost). The Switch determines this value based on the transmission speed (see table 6). It assi…